Operation Manual

Training Catalyst
- 4 - October 30, 2013
Functions during training
Start training
After Start training the Countdown will appear. When it has reached 0, you can start cycling. This is
also the starting sign for the opponents. In case of a false start the Countdown will begin again.
Pausing during training
If you stop training before crossing the finish line, a
Pause pop-up will appear on the screen. It contains the
pause time and current heart rate. All rider data are
held during the break. When you start cycling again,
the computer’s calculations will be based on these
data.
Power Mode
This function is used to adjust the difficulty of the current route while cycling. It can be done at any
time via the Enter button (VR interface) or right arrow (Bushido/Vortex/Genius computer). A pop-up
will appear where you change the Power Mode with up arrow and down arrow. When you do this, you
will have to save the program under another name after finishing. The opponents expire after
adjusting the Power Mode setting.
Finish
After finishing a pop-up will appear with your time and the time of the opponents. Click Save when
you want to keep this score. It can be viewed later through Analyser.
Stopping early
You can stop training before crossing the finish line by pressing the Cancel button (VR interface) or
left arrow (Bushido/Vortex/Genius computer). A pop-up will appear asking if you want to save the
part you have completed. If so, rename the program and click Save. The score can be viewed later
through Analyser.