Operation Manual

10 11

TRAINING WITH THE i-VORTEX

Training data

Both during and after a training session you have the possibility to browse the training data using

Arrow left and Arrow right. You can browse through the 7 following display functions:

1. Stopwatch, time cycled

2.DistancecoveredinKmorMi

3. Consumption in Kjoule or Kcal

4. Maximum and average speed

5. Maximum and average power

6.Maximumandaveragepedallingfrequency

7. Maximum and average heart rate

Average indicator

This function indicates if the training data in the yellow menu bar is right on, below or over average.

Setting training value

Using Arrow up or Arrow down you can adjust the setting’s value while training.

Setting training type

By pressing OK once the training type will start blinking. Using Arrow up or Arrow down you can

switchbetweentrainingtypes:Slope(inclinein%),Power(watt)andHeartrate(inbpm).Pressing

OK saves the choice.

Training with the i-Vortex

SCOPE

Scope speed

If the brake is incapable of attaining the power demanded at a given incline up- or down hill, virtual

speed is used. The speed indicated is the speed that corresponds to the set incline and current power

out put. Because it is not possible to set an even lower power for the brake, the indicated speed will

be higher. If uphill it is not possible to set an even higher power for the brake the indicated speed will

be lower. A horizontal bar will appear underneath the value in case of virtual speed.

Scope power

When the set power cannot be attained at the speed you are riding at a horizontal bar will appear

underneath the value for your information.

ERROR CODES

Error codes while riding

At www.tacx.com ›SERVICE,youwillfindtheFAQpertainingtothei-Vortex.Thisiswhereyoucanfind

updated information about what to do if an error code appears on your screen.

Scope & error codes