User's Manual

Make sure that the connector makes contact head on with the

J1W

ensuring no twist in the connection which may result in connector

damage. Removal of cables also requires the connectors to come off

without much twist, so that damage does not occur to the unit.

When using the USB cable, the

Joey1W’s

recorder draws power

directly from the computer through the cable.

After you are finished configuring the

Joey1W

, disconnect the

recorder from the USB cable. The recorder will remember it’s

configuration parameters and will operate according to those

parameters the next time power is applied.

1.5 Stand Alone Mode

Once the recorder is configured using the

Joey

program and

transmitter frequency has been programmed using a Citation Receiver,

Personal Computer, or PTX-100 programmer. The transmitter and

recorder will remember and use the current configuration each and

every time power is applied to the unit.

1.5.1 Making the Connections

For an operation, you must decide how you want to configure your

J1R

1. No matter what, you must

connect the antenna.

2. External tethered or internal microphone?

3. Is there a need for the optional, tethered remote ON/OFF switch?

See the diagram below for connector placement on the

J1W