User's Manual

1.3 Using the J1W Transcorder

The

J1W

is designed to be used,

 operationally in a stand alone configuration, or

 in conjunction with its USB cable and a personal computer

for configuration, downloading and replay of stored audio, or

 connected to a personal computer, TTI Citation Receiver, or

TTI PTX-100 for Transmitter Only Frequency Programming.

Before using the

J1R

in an operational environment, it should first be

run in PC Mode and the recorder configured using the accompanying

Joey

software. The Transmitter operating frequency must be

programmed separately.

NOTE: Transmitter must

be switched OFF while operating in PC Mode.

1.4 PC Mode – Recorder Operation

Install the

Joey

software and USB device drivers.

Using the USB cable supplied, connect the

J1R

to the computer and

configure the unit to the desired operational parameters by running the

Joey

software. Make sure the Transmitter ON/OFF switch is in the OFF

position.

To connect the USB cable to the

Joey1W

, align the arrow and yellow

dot on the USB Cable 6 pin connector with the yellow dot 6 pin

connector of the

J1W

unit. If you attempt to install the cable upside

down, you will damage the

Joey1W