User's Manual

Ensure that any material will not rub against the surface of the

microphone.

For maximum efficiency, the

J1W

antenna should be kept

vertical whenever possible. Placing the antenna on a metal

object may result in quite poor performance of the

J1W

’s

transmitter. The antenna should not be wrapped around the

J1W

, nor should it be coiled or bunched in a ball. The antenna

used for this transmitter must not be collocated or operating in

conjunction with any other antenna or transmitter. The antenna

must be installed to provide a separation distance of at least 20 cm

from all persons.

1.5.3 Operational Mode

When power is applied to the

J1W

via the master power switch, the

unit will wait for approximately three seconds, and then start to

record using its current configuration.

Note: The exception to this is if the unit has been previously

configured for timer mode. (See Error! Reference source not

found. Error! Reference source not found.)

Once the unit is recording, the transmitter will come on instantly when

the Transmitter Power Switch is turned ON (towards the red dot).

Removing power stops the recording and the RF transmissions.

Subsequent recordings and resumption of transmissions may be made

by re-applying power to the recorder. This is repeatable up until the

unit becomes full and cannot record any more audio. The transmitter

will still operate, even if the recorder is full..

When the operation is completed or the recorder becomes full, it

should be downloaded using the

Joey

program. The recorder does not

require power to retain its recordings and downloading can happen at

any time subsequent to a recording being made.