User Manual

a.) Press the CHNL button on the keypad.
b.) Observe the LCD Display.
c.) Using the UP or DOWN arrow keys, scroll to the
channel number you wish to use.
d.) Press the CHNL key again to lock in the selection.
OPERATING NOTES:
1.) Never Operate the ECHO-6 with the REPEATER OPERATING
MODE SWITCH in the RPT (REPEAT) position without having an
antenna connected to the unit.
2.) Keep the inside of the ECHO-6 dry. If it does get wet, wipe it dry
immediately. Liquids might contain minerals that can corrode the
electronic circuits and cause extensive damage.
3.) Handle the ECHO-6 with care. Dropping the unit may damage circuit
boards, the case, and/or the connectors rendering the unit inoperable.
4.) There are no user-serviceable parts in the ECHO-6. If for some
reason the unit needs service, please return it to the factory.
5.) Before using this equipment in any active investigation, please check
its operation and the operation of all other electronic components in your
system. Be sure to use fresh or fully charged batteries at all times for
optimum performance.
6.) Set Repeater Operating Mode Switch in the OFF position when not in
use.
7.) When using the earphone to monitor the reception in the ECHO-6,
the volume is fixed and can not be adjusted.
8.) Performance of the repeater is subject to many conditions. Of critical
importance is the placement of the antenna. Consult your salesperson
for more information.
9.) The LCD display are only illuminated after any key on the keypad is
pressed. If any key on the keypad is not depressed for 10 seconds, the
illumination automatically turns off.