User Manual

OPERATIONS
A.) Check Repeater Operating Mode Switch.
This is a three position rotating switch:
RIGHT Repeater's Transmitter and Receiver On (RPT)
LEFT System Off (OFF)
CENTER Receiver Only On - Monitor mode (MON)
Set the switch in the OFF position.
B.) Iinstall antenna in a position for maximum performance.
The antenna supplied with the standard ECHO-6 is a
unity gain quarter wave magnetic mount antenna.
Attach the female BNC connector found on the cable
end of the antenna on to the male BNC connector
marked ANT on the ECHO-6's outside panel.
The antenna's magnetic base should be installed on a
flat metal surface. An approximate radius of 19" around
the magnetic base will result in maximum antenna
performance efficiency.
C.) Select 12 VDC power source and connect to ECHO-6.
INTERNAL BATTERY
No additional setup is necessary to use internal battery.
EXTERNAL 12 VDC (Cable supplied)
1.) Align 4 pin locking female connector found on the
end of the cigarette lighter plug cable with the male
connector on the ECHO-6's outside front panel marked
PWR.
2.) Push connectors together, then turn the locking
sleeve on the cable end connector clockwise until it
stops. Do not overtighten.
3.) Connect the cable end to any appropriate 12 VDC
power source. Attach the RED cable lead to the source's
positive (+) 12 VDC terminal, and the BLACK lead to the
source's negative (-) terminal.