User's Manual

Terminal. Hyper-Terminal is supplied with Windows 95 and 98.
If Hyper-Terminal is installed, you can proceed. If you have not
installed this program onto your computer, please do so at this time.
Installing Hyper-Terminal:
a.) Select "START" from the Windows Task Bar
b.) Select "Settings" - "Control Panel" from the Start Menu
c.) Select "Add/Remove Programs" from the Control Panel
d.) Select the "Windows Setup" tab at the top of the window
e.) Double-click on "Communications" in the 'components' window.
f.) Click the box next to "Hyper-Terminal". This puts an X in the
box.
g.) Click "OK" at the bottom of the window.
h.) Click "OK" at the bottom of the new window.
i.) Follow the on - screen instructions about inserting you Windows
Installation disks or CD.
4.) Install the Hyper-Terminal TTI Transmitter Programming
Module:
a.) Insert the supplied 3 1/2 inch floppy disk into you computer's
disk drive.
b.) Select "START" from the Windows Task Bar.
c.) Select "RUN" from the Start Menu
d.) Type "a:\setup" in the white bar
e.) Select "OK"
f.) Follow the on screen instruction.
g.) Remove disk when finished.
PROGRAMING YOUR FREQUENCIES
1.) Connect the CST-703 programming cable to the top of the
transmitter via the round four pin connector. This connector is
keyed for proper installation. Be sure to lock down the connector by
twisting the screw ring clockwise until it snugs up to the panel
connector. DO NOT OVERTIGHTEN.
2.) Connect the D style 9 pin female connector to an open serial port
on your IBM compatible computer. If your computer's serial port is a
25 pin connector, you will need to use a DB25 to DB9 serial adaptor
(not included).
3.) Start the "TTI Transmitter Programming" software by clicking
it's icon located on the Windows Desktop.
4.) You must know the number of the Serial (Com) Port you have
attached the transmitter to. The software comes ready to work with
Com 1. If you are using Com 2, 3, or 4, you must perform the
following:
a.) Select "File" - "Properties" from the Hyper-Terminal Task Bar
b.) From the "Phone Number" tab, select your Com Port in the
"Connect Using" pull down menu. Select the "Direct to Com ___"
line that correlates to your Com Port.
c.) Select "OK" from the bottom of the window
d.) Your Com Port selection is automatically saved.
5.) Turn ON your Transmitter by applying a 9 VDC battery to the
connector found on the programming cable
6.) Type the letter "v" (for "verify"). At this time, the transmitter
will report its serial number and the frequency programmed into it
onto the Hyper-Terminal screen.
CST-703/VS SNxxxxx .50W
C 1546000
Line 1: Unit is a CST-703 voice transmitter (/V) equipped with
audio scrambling (S) and is serial number xxxxx. If this 703 was not
equipped with the scrambling option, the transmitter ID would be
CST703/V.
Line 2: Unit is programmed in CLEAR, unscrambled transmission