User's Manual

6
TO RETURN THE UNIT TO FULL PROGRAMMING MODE:
a.) With the unit in Field Secure Mode, turn the Citation 20 OFF. Use the small FSM tool
provided and insert it into the female RCA LINE jack found on the panel. Inside this jack is
a switch. Using the tool, lightly press on the switch, then extract the tool. When the switch
is dis-engaged, the Citation 20 will be in FULL PROGRAMMING MODE.
b.) Turn the POWER switch ON.
c.) Observe display - see that the numeric frequency information has returned.
d.) The Citation will remain in Field Secure Mode, regardless of power conditions, until
switched to revert back to FIELD SECURE MODE.
CLEARING THE MEMORY
Should it become necessary to clear the entire memory of the Citation 20:
1.) Turn the unit ON.
2.) Make sure the unit is in the FULL PROGRAMMING MODE.
3.) Select CHANNEL 00.
Press and hold the UP ARROW or DOWN ARROW key until CHANNEL 00 is on
the display.
or press the CHNL button and then type in 00 from the keypad
4.) Press and release the FREQ key.
5.) Press and release the ENTER key.
6.) Using the FSM tool, insert the tool into the LINE jack. Engage the FSM switch inside
the jack AND HOLD THE SWITCH IN THE ENGAGED POSITION FOR AT LEAST 3
SECONDS. Then release the switch.
7.) Depress this switch with the tool once again, to dis-engage the switch and return the unit
to FULL PROGRAMMING MODE.
8.) Observe the display, you will see the frequencies being erased, from 00 through 99.
9.) Turn the Citation OFF via the POWER switch.
10.) Turn the Citation ON via the POWER switch.
All the channels will now be erased.
NOTE: MAKE SURE YOU HAVE A WRITTEN COPY OF ALL YOUR FREQUENCY
INFORMATION BEFORE CLEARING THE MEMORY OF THE CITATION 20. THIS
PROCESS IS NON-REVERSIBLE.
NOTE: YOU CAN ERASE THE MEMORY FROM ANY CHANNEL NUMBER THROUGH
NUMBER 99 BY SELECTING ITS CHANNEL NUMBER INSTEAD OF 00 (step 3 above).
As an example - you have channel numbers 00-12 programmed with frequencies you
wish to keep. Channel 13, 20, 39, and 80 have information stored in them that you don NOT
need. Simply select channel '13' when you reach step 3 in the directions. The memory will
be cleared from channel 13 through 99, leaving the information in 00 through 12 intact.
You can NOT individually clear a specific channel, or an interior range of frequencies.
The range must go from a channel (with 00 being the lowest) through to 99.
ADD THE ANTENNA
Select either the Internal Antenna or the use of an External Antenna