User's Manual

demagnetized periodically using a commercial head demagnetizer.

NOTE: PLEASE REFER TO THE OPERATOR'S MANUAL FOR THE MARANTZ RECORDER

FOR FURTHER INFORMATION

REMOVING THE TAPE DECK FOR EXTERNAL USE

The Marantz tape recorder can easily be removed from the Citation 20, allowing it to be used in a

variety of other recording needs. It is held down to the control panel via four brackets, one on

each side and two in the rear. (For the PDM-650, there are 3 brackets, one on each side and one in

the rear).

TO REMOVE THE RECORDER...

1.) Turn the Citation 20's POWER switch OFF.

2.) Disconnect the three cables leading to the Marantz from the Citation's control panel:

a.) RECORDER POWER CABLE connected to recorder's POWER INPUT JACK.

When this cable is removed from the recorder, it must be inserted into the RECORDER

POWER CABLE HOLDER grommet .

b.) IN cable connected to LINE IN JACK .

c.) OUT cable connected to LINE OUT JACK .

3.) Completely loosen the two screws found on each of the two side brackets attached to the

HOLD DOWN PEGS on the recorder. Turn the screws counter-clockwise to remove them from

the control panel, but do NOT remove the screws from the brackets.

4.) Remove the brackets from the recorder by lifting them up slightly, then sliding them off the

PEGS.

5.) Gently slide recorder towards the front of the Citation. This will release the two rear hold

down brackets which were inserted into the RETAINER SLOTS . Do not loosen or remove these

brackets from the control panel. (For the PMD-650, this single bracket goes over the top of the

recorder).

7.) Once the recorder has cleared the rear brackets, lift the unit off the control panel.

TO REPLACE THE RECORDER:

1.) Align the rear hold down brackets with the RETAINER SLOTS in the recorder and gently slide

the tape deck slots over the brackets. (For the PMD-650, slide the tapedeck underneath the

bracket.)

2.) Replace side brackets onto the recorder's HOLD DOWN PEGS, and screw brackets onto the

control panel. Make sure screws line up exactly with the holes in the panel BEFORE you attempt

to replace them. Cross threading these screws may cause damage that will not allow the recorder

to be held securely to the control panel. Use a small screw driver to tighten the screws down

snugly to the control panel.

3.) Replace all cables into their correct jacks on the recorder.

USING THE TWO "DIGITAL AUDIO CONTROL"

ADJUSTMENTS