User's Manual

Bar.
b.) From the "Phone Number" tab, select your Com Port in the
"Connect Using" pull down menu. Select the "Direct to Com
___" line that correlates to your Com Port.
c.) Select "OK" from the bottom of the window
d.) Your Com Port selection is automatically saved.
5.) Connect a 9 VDC battery to the battery terminal leads found
on the programming cable, and turn ON your Transmitter.
At this time, your computer screen should look similar to the
following screen shot:
Here are some commands to become familiar with:
f..........Begins the New Frequency programming
sequence.
v..........Verifies the frequency that is currently
programmed in the transmitter.
c.........Selects CLEAR transmission mode (for
units equipped with scrambling).
s..........Selects SCRAMBLE transmission mode (for
units equipped with scrambling).
Remember: All commands are lower case letters.
6.) Begin by VERIFYing the information about your transmitter.
Type a v.
Immediately upon your entering a "v", the program will report the unit's
ID (CTR-751/V) , and the frequency that is programmed into the current
channel. If your transmitter is equipped with scrambling capabilities, this
will be noted with an "S" after the model number (CTR-751/VS), and
whether the unit is in scrambled mode or clear mode (noted with a "c"
or an "s" before the frequency notation). The screen will look something
like this:
7.) Program your frequency
Type an f.