User's Manual

INSTALLING YOUR TRANSMITTER SOFTWARE
1.) The computer program supplied to install the frequencies into
your CTR-751 transmitter is a module written for Microsoft's
Hyper-Terminal. HyperTerminal is supplied with Windows 95 and
98 and XP. If HyperTerminal is installed, you can proceed. If you
have not installed this program onto your computer, please do so
at this time.
Installing HyperTerminal in Windows:
a.) Select "START" from the Windows Task Bar
b.) Select "Settings" - "Control Panel" from the Start Menu
c.) Select "Add/Remove Programs" from the Control Panel
d.) Select the "Windows Setup" tab at the top of the window
e.) Double-click on "Communications" in the 'components'
window.
f.) Click the box next to "HyperTerminal". This puts an X in the
box.
g.) Click "OK" at the bottom of the window.
h.) Click "OK" at the bottom of the new window.
i.) Follow the on - screen instructions about inserting your
Windows Installation CD.
2.) Install the HyperTerminal TTI Transmitter Programming
Module:
a.) Insert the supplied 3 1/2 inch floppy disk into you computer's
disk drive.
b.) Select "START" from the Windows Task Bar.
PROGRAMMING YOUR TRANSMITTER OPERATING
FREQUENCY
FROM AN
IBM COMPATIBLE PC
SERIAL PORT
1.) Connect the CTR-751 TX programming cable to the top of
the transmitter via the 6 pin connector. This connector is keyed
for proper installation. The cable will be marked with a "TX" -
indicating it is the cable for transmitter programming.
2.) Connect the D style 9 pin female connector to an open serial
port on your IBM compatible computer. If your computer's serial
port is a 25 pin connector, you will need to use a DB25 to DB9
serial adaptor (not included).
3.) Start the "TTI Transmitter Programming" software by
clicking it's icon located on the Windows Desktop.
4.) You must know the number of the Serial (Com) Port you
have attached the transmitter to. The software comes ready to
work with Com 1. If you are using Com 2, 3, or 4, you must
perform the following:
a.) Select "File" - "Properties" from the HyperTeminal Task
c.) Select "RUN" from the Start Menu
d.) Type "a:\setup" in the white bar
e.) Select "OK"
f.) Follow the on screen instructions.
g.) Remove disk when finished.
JOEY'S VHF VOICE TRANSMITTER