User's Manual

RECORDING AND PLAYBACK
NOTE: If the REC programming/download cable is connected to the
Joey, recordings can only be initiated via the Whisper Player
software.
Each time power (or a short) is applied a new FILE number and
recording will be created on the device.
Configuring the recorder for operations - programming
1.) Connect the CTR-751 REC programming/download cable to the
top of the Joey via the 6 pin connector. This connector is keyed
for proper installation. The cable will be marked with a "REC" -
indicating it is the cable for transmitter programming.
2.) Connect the D style 9 pin female connector to an open serial
port on your IBM compatible computer. If your computer's serial
port is a 25 pin connector, you will need to use a DB25 to DB9
serial adaptor (not included).
3.) Start the "Whisper Player" software.
4.) You must know the number of the Serial (Com) Port you have
attached the Joey to. The software comes ready to work with Com
1. If you are using Com 2, 3, or 4, you must select that port via the
"Serial Port" area of the software. Your serial port should be
configured for a data transfer rate of 115k baud.
5.) Apply power to the Joey by attaching a 9 VDC battery to the
battery connector found on the REC programming/download cable.
Once power is applied, the Joey and the software will 'handshake'.
After about 10 seconds, the software will report that the Joey is
ONLINE via the following response: $WSP, ONLINE. You will
see this in the Whisper Player Communications Window found in
the lower left corner of the software screen.
NOTE: You must wait for the Joey to report that it is ONLINE
before you can continue. If the unit does not report, disconnect
the 9 VDC battery, wait 5 seconds, then reapply the power to the
unit.
6.) Press the "LIST" button to see if the recorder has files
previously recorded on it. If the Joey has files on it, your
computer screen will look something like this: