Operator's Manual

INSTALLING YOUR SOFTWARE
1.) The computer program supplied to install the frequencies into your
CST-2001 transmitter is a module written for Microsoft's Hyper-
Terminal. HyperTerminal is supplied with Windows 95 and 98.
If HyperTerminal is installed, you can proceed. If you have not
installed this program onto your computer, please do so at this time.
Installing HyperTerminal:
a.) Select "START" from the Windows Task Bar
b.) Select "Settings" - "Control Panel" from the Start Menu
c.) Select "Add/Remove Programs" from the Control Panel
d.) Select the "Windows Setup" tab at the top of the window
e.) Double-click on "Communications" in the 'components' window.
f.) Click the box next to "HyperTerminal". This puts an X in the box.
g.) Click "OK" at the bottom of the window.
h.) Click "OK" at the bottom of the new window.
i.) Follow the on - screen insturctions about insterting you Windows
Installation disks or CD.
4.) Install the HyperTerminal TTI Transmitter Programming Module:
a.) Insert the supplied 3 1/2 inch floppy disk into you computer's disk
drive.
b.) Select "START" from the Windows Task Bar.
c.) Select "RUN" from the Start Menu
d.) Type "a:\setup" in the white bar
e.) Select "OK"
f.) Follow the on screen insturctions.
g.) Remove disk when finished.
PROGRAMING YOUR
FREQUENCIES
1.) Connect the 2001 program-
ming cable to the top of the
transmitter via the round four
pin connector. This connector
is keyed for proper installation.
Be sure to lock down the
connector by twisting the screw
ring clockwise until it snugs up
to the panel connector. DO
NOT OVERTIGHTEN.
2.) Connect the D style 9 pin
female connector to an open
serial port on your IBM
compatable computer. If your
computer's serial port is a 25 pin
connector, you will need to use a DB25 to DB9 serial adaptor (not
included).
3.) Start the "TTI Transmitter Programming" software by clicking it's
icon located on the Windows Desktop.
4.) You must know the number of the Serial (Com) Port you have
attached the transmitter to. The software comes ready to work with
Com 1. If you are using Com 2, 3, or 4, you must perform the
following:
a.) Select "File" - "Properties" from the HyperTeminal Task Bar
b.) From the "Phone Number" tab, select your Com Port in the