Operator's Manual

BATTERY INSTALLATION
1.) Remove battery cover off unit by gently sliding
the battery compartment cover down and away
from the transmitter housing. Slight pressure may
be needed to release the small dimples found near
the bottom of the cover.
2.) Install 4 each standard AAA Alkaline batteries
- Make sure you observe polarity as indicated
inside battery compartment.
3.) Replace battery cover. Be sure to insert both
sides of cover into the grooves on each side of the
battery compartment. Cover slides easily up
towards the top of the housing.
NOTE: It is important to keep the cover aligned
perpendicular with the transmitter housing when
removing or replacing it.
Slide Lid
-------- >