User's Manual

T200

TRANSCEIVER

OPERATING INSTRUCTIONS

These operating instructions are intended to provide the user with sufficient information to install

and operate the unit correctly.

The Tactical Electronics model T200 is a single channel synthesized transceiver which operates in the

216 to 219MHz frequency band. The unit is intended to fulfil the numerous OEM applications by

virtue of its highly reliable design, miniature size and quality manufacture.

INSTALLATION

The T200 is intended to fit easily and with minimum space requirements into the user's own

equipment housing. The complete module is housed within a tin-plated enclosure and is secured

by means of four 10mm metal screws which locate in the four corners through the lower

screening cover. DO NOT overtighten these screws during assembly.

PAGE 1
T200 TRANSCEIVER OPERATING INSTRUCTIONS These operating instructions are intended to provide the user with sufficient information to install and operate the unit correctly. The Tactical Electronics model T200 is a single channel synthesized transceiver which operates in the 216 to 219MHz frequency band. The unit is intended to fulfil the numerous OEM applications by virtue of its highly reliable design, miniature size and quality manufacture.
PAGE 2
CONNECTION The radio antenna connects by means of a BNC miniature coaxial connector. All other connections to the T200 transceiver are made using a standard 9-way D type connector as detailed in the table below. PIN NAME 1 MOD I/P 2 FUNCTION REMARKS Data modulation input To transmitter, TTL/CMOS compatible DATA O/P Receiver Output 5V CMOS levels, high ( +5V) when no signal present 3 Tb Xb Eb transmit enable HIGH >2.5V = receive LOW <0.
PAGE 3
RUNNING THE SOFTWARE Please note that mouse operation is not supported with this program Figure 1 Programming adaptor 1. Connect TX00 to a suitable supply and to the PC using the programming adaptor. 2. Insert the TPRG disk into drive A and type: A:TPRG 3. The user is then prompted to enter the serial port number of his PC which is used to communicate with the TX00 transmitter. Enter 1 or 2.
PAGE 4
RANGE INFORMATION The following table gives an indication of the typical ranges to be expected between a transmitter and receiver that have simple end-fed dipole antennas.