User's Manual

70-STR1700-000 Rev A.1 STR-1700 O&M Manual
5
SECTION 2 RECEIVING, INSPECTION AND INSTALLATION
2.1 Unloading and Unpacking
NOTE
If shipping carton is damaged upon receipt,
request carrier’s agent be present during unpacking
and inspection of the system.
Upon receipt of the equipment, inspect the shipping container for damage. If
the container or the cushioning material is found damaged, they should be kept
until the contents of the shipment have been verified for completeness and the
equipment has been inspected for mechanical and electrical defects. If the
contents are incomplete or if there is a mechanical or electrical defect,
please notify:
SUMMATION RESEARCH, INCORPORATED
751 North Drive
Melbourne, Florida 32934
2.2 Receiving Documentation
Each STR-1700 system is shipped with a packing slip. The packing slip should
be carefully checked against the contents of the shipping container.
2.3 Installation and Connection Requirements
The STR-1700 has three (3) connectors. These are:
1) Primary Power
2) Antenna
3) Audio/control
After carefully reviewing the connector and signal descriptions below, the
user should establish all connections, making sure that the primary power
input is turned off at the source. Once all interconnections are in place,
primary power may be applied.
2.4 Connector Descriptions and Signal Definitions
This section describes the types of connectors used on the STR-1700 and
provides the definition of the signals associated with each.
2.4.1 Primary Power
The Primary Power connector is located on the rear of the STR-1700 and is
attached to the unit itself via approximately 6 inches of 12 gage wire.
Characteristics of this connector are as indicated in the following table.