User Manual

11
CH 2 Elevator
2AI & Normal
CH 3 Throttle
CH 4 Aileron 2
CH 5 Aux 1
CH 6 Rudder
CH 7 Aux 2
CH 8 Aux 3
CH 1 Aileron 1
CH 2 V- tail 1
2AI & V-tail
CH 3 Aileron 2
CH 4 V-tail 2
CH 5 Throttle
CH 6 Aux 1
CH 7 Aux 2
CH 8 Aux 3
CH 1 Aileron 1
CH 2 Ailevator 2
2AI & Delta
CH 3 Throttle
CH 4 Rudder
CH 5 Aux 1
CH 6 Aux 2
CH 7 Aux 3
CH 8 Aux 4
CH 1 Ailevator 1
CH 2 Elevator 1
2AI & 2 Elev
CH 3 Aileron 2
CH 4 Elevator 2
CH 5 Throttle
CH 6 Rudder
CH 7 Aux 1
CH 8 Aux 2
CH 1 Aileron 1
2AI: This “2 ailerons” setting is for airplanes having one aileron servo for each wing. Connect one aileron
servo to Rx channel 1, and the other to another channel as listed in the tables above. This setting allows
each aileron servo to function independently of the other.
2AI1FL: This “2
ailerons + 1 fl ap” setting
is for airplanes having
two separate aileron
servos, requiring one
servo to control each
aileron, and also one
servo (or 2 servos on
a Y-harness) that will
control flaps for both
wings simultaneously
(not available for
2-elevator tail settings).
CHANNEL ASSIGNMENTS
This function allows transmitter channels to be re-
assigned to different outputs before being sent to the
receiver. This can be useful for models having unusual
confi gurations.
Some small electric fl ight models use only elevator,
throttle, and rudder channels (not aileron). Here, it’s
often preferred that the rudder be controlled with the
opposite stick (right stick for Mode 2 confi gurations).
Such channel re-assignment can be done in this screen.
Determine which Tx channel input on the left should control which output channel at the receiver as shown
on the right. Move the cursor to the desired output on the left. Press ENTER then or to adjust the
output channel as desired. Press ENTER when fi nished.
CH 2 Elevator
2AI1FL & Normal
CH 3 Throttle
CH 4 Aileron 2
CH 5 Flap
CH 6 Rudder
CH 7 Aux 1
CH 8 Aux 2
CH 1 Aileron 1
CH 2 V- tail 1
2AI1FL & V-tail
CH 3 Aileron 2
CH 4 V-tail 2
CH 5 Throttle
CH 6 Flap
CH 7 Aux 1
CH 8 Aux 2
CH 1 Aileron 1
CH 2 Ailevator 2
2AI1FL & Delta
CH 3 Throttle
CH 4 Rudder
CH 5 Flap
CH 6 Aux 1
CH 7 Aux 2
CH 8 Aux 3
CH 1 Ailevator 1
Channel Assignments
Channel1 Output1
Channel2 Output2
Channel3 Output3
Channel4 Output4
Channel5 Output5
Channel6 Output6
Channel7 Output7
Channel8 Output8