User Manual
42
4. During the rst ight, it might be necessary to re-trim the main channels to allow
the model to sustain smooth, even ight. If further adjustments are required on
the ground, make sure to turn off the engine or ESC/motor beforehand.
5. When the ight is completed, remove power from the system as described before.
Shut down power to the electronic speed control or glow engine rst, then the
receiver, and nally the transmitter.
● NEVER allow water or moisture to make contact with the electronic
components inside the transmitter, receiver, servos, switch harness, etc.!
This could lead to failure or improper functionality of components and
poor control of aircraft which could pose a safety hazard.
● NEVER operate R/C model aircraft near power lines, radio or cell phone towers, roads
or automobiles, buildings, or pedestrians. Be very careful in locations where many
R/C aircraft are being used simultaneously.
● NEVER operate R/C equipment if you are physically impaired as it could pose a safety
hazard to yourself or others in the area.
● NEVER allow small children to operate/control model R/C equipment without the
supervision of an adult.
● NEVER allow the transmitter’s throttle stick to accidentally be moved away from the
“off” or minimum position while the model’s engine/motor is moving.
● ALWAYS range check the radio system before use.
● ALWAYS make sure that all transmitter stick movements operate all servos properly
in the model. Check the proper operation of control surfaces before and after starting
the engine/motor.
● ALWAYS make sure the transmitter antenna is unfolded entirely so that it’s pointing
upright to ensure max. range and control of the aircraft.
● Do not store your radio equipment in extremely hot or cold locations, in direct sunlight,
or in locations with high humidity. Store R/C equipment in cool and dry locations.
● Do not allow chemicals to come in contact with any parts of the radio system.
Substances such as glow fuel, gasoline, CA glue, etc. could permanently damage
plastic parts of the radio system.
● If rechargeable batteries were installed in the transmitter, remove the batteries before
placing the radio in long-term storage.
IMPORTANT WARNINGS and PRECAUTIONS