User Manual

40
3. Move the cursor over “99sec”. This time determines how long before the radio’s
output power automatically returns to full power.
4. Place the Rx/model on the ground and apply power to the Rx/model.
5. Hold the Tx as it will be held during  ight and press ENTER. The range test timer
on-screen will start to count down. Tones will sound to identify that this function
is active.
6. Move the Tx 100 feet away from the model and con rm all controls are transferred
smoothly at all times.
The counter will reset once the timer has expired, and reset to 99 seconds. The radio
will return to full output power at this time. Pressing ENTER any time during countdown
will stop the timer.
The following indications will sound and/or show if any of the following occur:
LOW BATTERY: Battery voltage is at or below the BATT ALARM setting. Cannot
change memories at this time. Replace or re-charge batteries.
RF ON / OFF?: Turn the radio’s RF signal on or off.
THRO POS.: The throttle stick is >50% full de ection at start-up. Move the throttle
stick to minimum.
THRO CUT: The throttle cut function has been set and the switch is on.
THRO HOLD: The throttle hold function has been set and the switch is on.
NO SIGNAL: While in training mode, if the signal between the teacher and student
transmitters becomes un-linked.
AUTO SHUTDOWN: If no transmitter stick or control is
moved after 10 minutes have elapsed, this warning screen will
show and the Tx will proceed to shut itself down to prevent
unwanted drainage of the batteries. If the transmitter’s RF
section is turned ON, the Tx will automatically shut down
120 seconds after this message shows. If the RF section
is turned OFF, the Tx will shut down 60 seconds after this
message shows. Moving the sticks will turn this warning off.
WARNING! Always make sure that power is applied to the transmitter
BEFORE applying power to the receiver and servos, and the Tx throttle
stick is at minimum (idle) position. Failure to do so could result in the
model becoming uncontrollable and cause a safety hazard. During all
pre- ight preparations, do not stand the Tx upright on the ground. Carefully lay the Tx
on its back on the ground to prevent it from falling over and possibly dislodging the
throttle stick which would create a safety hazard. Make sure all devices are properly
mounted inside the model, and all wiring connections are solid to prevent them from
WARNING INDICATIONS
5.1V
>Axe100F
02
AUTO SHUTDOWN
103S
CAUTION!!
SYSTEM CHECK AND OPERATIONS