User Manual

3. Move the student’s transmitter to within 3 feet of the teacher’s transmitter, turn
the power switch on and set the RF OUTPUT to ON.
4. The TTX410/610 LED should  ash three times and then stay on to indicate the
bind was complete. Release the trainer switch.
5. Once linked, move the throttle stick on both transmitters to minimum. Turn the
Rx power on and make sure only those channels selected for transfer to the
student are transferred when the TTX660 trainer switch is de ected. Ensure the
teacher can regain control of all channels when the trainer switch is released.
6. Perform a complete range check before  ight.
7. When the training session has ended, with the model safely landed and power
removed from the model simply turn the power switch for both transmitters to
the OFF position. This will terminate the wireless link between both transmitters.
Teacher and student’s radio: TTX660
1. Link the teacher’s radio to the Rx.
2. In the teacher’s TRAINER screen described on page 18 select which channels
NOT to transfer to the student while training, and select a switch to control the
training function. Switch F is the recommended switch for training purposes.
Then turn the teacher’s Tx off.
3. Move the student’s transmitter to within 3 feet of the teacher’s transmitter.
4. Pull the teacher’s selected trainer switch and turn the power switch on. The
“searching” message should show on screen.
5. Turn the student’s radio on, and set the RF OUTPUT to ON.
6. The TTX660’s “searching” screen should disappear. The teacher can release the
TTX660 selected trainer switch. If the TTX660 doesn’t identify the signal from
the student’s radio a “NO SIGNAL” message will show.
7. Once linked, move the throttle stick on both transmitters to minimum. Turn the Rx
power on and make sure only those channels selected for transfer to the student are
transferred when the TTX660 selected trainer switch is de ected. Ensure the teacher
can regain control of all channels when the selected trainer switch is released.
8. Perform a complete range check before  ight.
9. When the training session has ended, with the model safely landed and power
removed from the model, simply turn the power switch for both transmitters to
the OFF position. This will terminate the wireless link between both transmitters.
Before each  ight make sure to check the operating range
of the Tx / Rx set. The TTX660 includes a function that
automatically reduces its output power to prevent having
to walk a long distance to check the range.
1. Make sure the Tx throttle stick is at minimum position.
2. Enter the “RF OUTPUT” screen in the FUNCTION
menu, as described on page 28. Leave the “RF ON/
OFF” selection ON.
RANGE TEST
RF OUTPUT
RF ON/OFF : ON
RANGE TEST :99sec