User Manual

3838
IMPORTANT! Before  ying the model in training situations it’s very
important to make sure all channel reverse settings and trim adjustments
on the teacher and student transmitters match! Otherwise, the model
could suddenly veer in an unwanted manner when the teacher’s trainer
switch is activated. Proper matching of the student and teacher’s Tx settings should
ensure that no unexpected movements occur when the trainer switch is pressed. This
is especially true of the throttle control!
Teacher’s radio: TTX660 Student’s radio: Tactic TTX410 or TTX610
1. Link the teacher’s TTX660 to the Rx inside the model, and then remove power
from the Rx.
2. In the TTX660 TRAINER screen described on page 18 select which channels
NOT to transfer to the student while training, and select a switch to control the
trainer function. Switch F is the recommended switch for training purposes.
3. Turn the teacher’s Tx off.
4. Pull the TTX660’s selected
trainer switch and hold it in
this position while turning
the power switch on. The
“searching” message should
show on-screen.
5. Move the student’s transmitter
to within 3 feet of the
teacher’s transmitter and turn
on the TTX410/610 power switch.
6. The TTX660’s “searching”
screen should disappear.
The teacher can release
the trainer switch. If the
TTX660 doesn’t identify the
signal from the student’s
radio a “NO SIGNAL”
message will show.
7. Once linked, move the
throttle stick on both transmitters to minimum. Turn the Rx power on and make
sure only those channels selected for transfer to the student are transferred
when the TTX660 selected trainer switch is de ected. Ensure the teacher can
regain control of all channels when the selected trainer switch is released.
8. Perform a complete range check before  ight.
9. When the training session has ended, with the model safely landed and power
removed from the model, simply turn the power switch for both transmitters to
the OFF position. This will terminate the wireless link between both transmitters.
Teacher’s radio: Tactic TTX410/610 Student’s radio: Tactic TTX660
1. Link the teacher’s TTX410/610 to the Rx. Remove power from the model, and
then turn the teacher’s Tx off.
2. Pull the TTX410/610 trainer switch and hold it in this position and turn the power
switch on.
5.0V
>Axe100F
02
OOO
OOO
SEARCHING
4.9V
>Axe100F
02
OOO
OOO
NO SIGNAL