User Manual

36
Once inside this function, press
ENTER to highlight the “Rate”
value. Press or to  nd the
desired maximum rate. The circle
graphic represents the maximum
movement rate. Moving the aileron
and/or elevator stick to their limits
will cause the actual position of the
these controls to show at the bottom
of the screen.
PROGRAMMABLE MIXER, RF OUTPUT
AND TIMER
Setting of programmable mixes for helicopters and drones is identical to that for airplanes,
as described on page 27. RF output and timer settings of these functions are identical
to that for airplanes as explained on page 28.
The Throttle Hold and Gyro Mixing functions in the helicopter section of this manual
also apply to drones.
The Channel Delay function allows for a time delay to be applied between when one of
the sticks is moved and the resulting control in the model changes. This can be helpful
for highly responsive drone models. Adjust the time delay as desired.
All other functions/settings for drones are covered in the airplane menu of this manual.
Refer to those sections of this manual as needed.
Linking the TTX660 to the Tactic receiver ensures sole communication between the two,
and prevents other transmitters from being able to control the receiver.
1. Turn on the Tx. (Make sure RF Output is set to ON.)
2. Apply power to the Rx.
3. If the Rx LED  ashes once and then stays on, the Rx is already linked to the Tx and
you can skip to the next section. Otherwise, insert a small diameter screwdriver
through the hole marked “LINK” or “BIND” on the Rx and press the pushbutton
until the Rx LED glows red and then turns off after about one second.
SWASH RING
RATE : 150%
ELEV :
AILE:
0%
0%
SWASH RING
RATE : 88%
ELEV :
AILE:
0%
0%
SWASH RING
RATE : 88%
ELEV :
AILE:
-58%
+65%
DRONE MENUS
LINK THE RECEIVER TO THE TRANSMITTER