User Manual

34
GYRO MIXER
This function is for setting and adjusting the sensitivity of an optional tail gyro. Enter
this screen.
To make the gyro mixing active at all times do NOT assign a switch at the CTRL line.
Press ENTER to highlight the normal mixing rate, and press or to  nd the desired
value. Press ENTER when  nished.
To control the mix with a switch, move the cursor to the CTRL line and press ENTER.
De ect the desired switch to control the mix. The screen will show the functional
assignments for each position of the switch (see page 20 for details). Press ESC to
con rm the switch selection.
The display will now show the different switch positions (SP.0, SP.1, SP.2). A different gyro
mixing rate can be set for each switch position. De ect the switch to one position and
note the cursor on-screen will automatically move to the percentage for that position.
Adjust the rate as desired and press ENTER when  nished. De ect the switch to the
remaining positions and repeat.
To clear a switch that was set to control the mix or hold, highlight the switch and press
CLEAR. A positive value equals “Heading Hold” while a negative value equals “Non-
Heading Hold.”
SWASH MIXER
This mix is not available when using
the “1 Servo” swash setting. This
function adjusts the mixture rate
of the pitch, aileron, and elevator
channels for the swash plate. Move
the cursor to the value to adjust, and
change as necessary.
Normal Switch Control
GYRO MIXING
NORM : 0%
CTRL :-----
GYRO MIXING
SP .0: 0%
SP .1: 0%
SP .2 : 0%
CTRL :SE(2)
SWASH MIXING
Pitc : +61%
Aile : +61%
Elev : +61%