User Manual

RUDDER MIXING

Mixing the rudder channel to the aileron and/or elevator channels can be very useful

for trimming an airplane to be neutral when using the rudder.

Select the rudder channel to mix to the aileron or elevator channels as needed. This

mix can be active at all times by not selecting a switch on the CTRL line. Or, for on/off

control of this mix select a control switch at the bottom of the screen.

FLAP MIXER

Normal Flap > Ail X

Flap > Ele X X

Flap > Flap X

Delta Flap > Ail

Flap > Flap X

1 Ail, 2 Ail,

Tail type Mixing 1 Ail 1 Flap 2 Ail 1 Flap

This function allows  aps to be set, adjusted, and mixed to the ailerons and/or elevator

channels. Mixes such as  aperons, air brake, and spoilers can be achieved in the

FLAPMIXER. These settings or mixes can be assigned and activated by a two or three

position switch. Not available for 1AI or 2AI wing types. Different setup options are

available depending on the selected wing type, where the  aps can be mixed to the

aileron, elevator, or back to the  aps.

Normal Switch Control

RUDD-> AILE MIXING

Aile Elev

NORM : 0% 0%

CTRL :-----

RUDD->AILE MIXING

Aile Elev

SP .0: 0% 0%

SP .1: 0% 0%

SP .2 : 0% 0%

CTRL :SE(0)

RUDD->ELEV MIXING

Aile Elev

SP .0: 0% 0%

SP .1: 0% 0%

SP .2 : 0% 0%

CTRL :SE(1)