User Manual

20
Moving the control stick for the channel shown on-screen will change the position of
the vertical line in the graph. The point where the vertical line intersects the diagonal
line is shown at the bottom-left on the screen. The “x” (horizontal) coordinate is on the
left, and “y” (vertical) coordinate is on the right.
Repeat the above steps for the aileron, elevator, and rudder channels as desired.
CH5 AND CH6 SET
Enter this screen to set the functions of channels 5 and
6. At the INPUT line select CH5 or CH6. Then follow the
steps below.
Control: Choose which switch, dial, or slider will control the selected channel. Switches
are identi ed by letters A through J, as printed on the transmitter next to each control.
On-screen the switches will be identi ed as “SA” for switch
A, “SH” for switch H, and so on. Move the control which
will ultimately control this function.
The display will show a graphic representing the control,
and the different positions of the control as shown here
(0, 1, and 2). The default position for “0” will always be in
the up direction. The control positions of the switch can
be assigned to  t personal preference. To use the default
settings, simply press ESC to con rm. To change the
control locations of the switch to be high “H”, medium “M”,
or low “L” position, press or to move the cursor to
the position to be changed. Press ENTER to highlight the
function at this position. Then press or to change
the control function. Repeat as necessary for all switch
positions. Press ESC when  nished.
To remove the switch that has been set in the Control
function, press ENTER to highlight the switch selection
and press CLEAR.
Other functions in this radio allow for assigning a switch
to a speci c function. Refer back to this section as needed.
Offset: Move the cursor to this function. Press ENTER, then or to  nd the
percent to offset the center position of the channel shown on this screen.
CH5 AND CH6 SET
INPUT :CH5
CTRL :-----
OFFSET : 0%
TRAVEL :+100% +100%
CH5 AND CH6 SET
INPUT :CH5
CTRL :
OFFSET : 0%
TRAVEL :+100% +100%
L:(0)
M:(1)SC
H:(2)
CH5 AND CH6 SET
INPUT :CH5
CTRL :
OFFSET : 0%
TRAVEL :+100% +100%
L:(0)
SD
H:(1)