User Manual

CHANNEL ASSIGNMENTS

This function allows transmitter channels to be re-assigned to different channels before

being sent to the receiver. This can be useful for models having unusual con gurations

or inaccessible receivers.

Some small electric  ight models use only elevator, throttle,

and rudder channels (not aileron). Here, it’s often preferred

that the rudder be controlled with the opposite stick (right

stick for Mode 2 con gurations). Such channel re-assignment

can be done in this screen.

Determine which Tx control input on the left (TXCH) should

control which output channel at the receiver as shown on

the right (OUTPUT). Move the box to the desired input control

on the left. Press ENTER then or to  nd the output

channel as desired. Press ENTER when  nished.

WARNINGS

Warnings can be set to alert you of undesirable switch or

throttle positions when the radio power switch is  rst turned

on. For example, if the throttle is at full when you turn on the

radio, you would see and hear an alarm. The alarms shown

can be set to ACT (active) or INH (inhibited).

THRO POS: The warning sounds

when the throttle stick is over 25%.

Clear the alarm by moving the stick

down. NOTE: If you are in heli mode,

and you have an Idle-up programmed,

this alarm will also sound to indicate

that you have an Idle up switch active.

THRO CUT: The warning will sound

when this switch is on. Turn off the

switch to clear the alarm.

THRO HOLD: The warning will sound

when this switch is on. Turn off the

switch to clear the alarm.

CHANNEL ASSIGNMENTS

TXCH OUTPUT

CH1 Output1->

CH2 Output2->

CH3 Output3->

CH4 Output4->

WARNING SET

THRO POS:INH

THRO CUT:ACT

THROHOLD:ACT

5.1V

> Oxo100E

THR POS.

CONTINUE? YES