User Manual

WING TYPE

This is for setting the type of tail and wing con guration for

the model. Depending on the mixes used and setup of the

aircraft, it might be necessary to change the aileron, elevator,

or rudder reversing settings to achieve the proper throw

directions for the model.

FLAP SETTINGS

The “FLAP” setting allows for con guration of the ailerons and/or  aps of the airplane.

Move the cursor over “1AI” to select from the following options:

1AI: Use this “1 aileron” setting for normal wing types having one aileron on each

wing, where by utilizing a Y-harness one servo input controls the movements of

both servos simultaneously.

1AI1FL: This “1 aileron + 1  ap” setting is for wings having one servo that controls

the ailerons on both wings, and another servo (or 2 servos on a Y-harness) that

controls the  aps on both wings (both servos moving in the same direction). Connect

the aileron servo to Rx channel 1, and the  ap servo to channel 5. (Not available

for delta.)

2AI: This “2 ailerons” setting is for airplanes having one aileron servo for each wing.

Connect one aileron servo to Rx channel 1, and the other to channel 6. This setting

allows each aileron servo to function independently of the other.

2AI1FL: This “2 ailerons + 1  ap” setting is for airplanes having two separate aileron

servos, requiring one servo to control each aileron, and also one servo (or 2 servos

on a Y-harness) that will control  aps for both wings simultaneously. (Not available

for 2 elev tail settings.)

TAIL SETTINGS

“Normal” is the factory default setting for the “TAIL” type. Move the cursor over “Normal”,

press ENTER then or to select from V-Tail, Delta (elevon), and 2 Elevator options.

Press ENTER to con rm the selection. The charts below can aid in determining the

preferred tail and  ap setting for the model.

Normal: One servo each is used

for aileron(s), elevator(s), and

rudder.

1AI

Normal

FLAP

TAIL

Airplane - Normal Tail

1AIL/ 2AIL/

1AIL 1FLAP 2AIL 1FLAP

CH1 AIL AIL AIL AIL

CH2 ELEV ELEV ELEV ELEV

CH3 THRO THRO THRO THRO

CH4 RUDD RUDD RUDD RUDD

CH5 AUX1 FLAP AUX1 FLAP

CH6 AUX2 AUX2 AIL2 AIL2