User Manual

14
Copy: To copy all parameters from one model memory to another, place the cursor over
“Copy” and press ENTER. The “COPY FROM” page will show. Highlight the memory
to copy FROM and press ENTER. Now the “COPY TO” page will show.
Place the cursor over the memory number to copy TO, and press ENTER. The con rmation
screen will show.
To NOT proceed with the copy function as shown on-screen, highlight “NO” and press
ENTER to cancel and return to the main MODEL MANAGEMENT screen.
Otherwise, press to highlight “YES” and press
ENTER. All settings that previously existed in the
receiving memory will be permanently erased.
The display will return to the main MODEL
MANAGEMENT screen. Return to the MODEL
SELECT screen to con rm the copy function
was successful by looking at the memory that
was copied “to”.
Reset: To change the parameters of any single
memory except model type and model name use
this reset function. Enter this screen, move the
cursor over the memory to reset and press ENTER.
Select “NO” to cancel or “YES” to proceed with
the reset, and press ENTER.
Erase: Use the erase function to completely clear
all settings in any single memory to factory default
settings. The method for selecting, cancelling, and
approving this function is the same as for reset.
You will be forced to select a model type before
proceeding (airplane, helicopter, or drone).
02 : Axe 100
03 : Extra
04 : Cirrus
05 : Novus
06 : Y ak-54
01 : GeeBee
COPY
FROM
COPY
TO
02 : Axe 100
03 : Extra
04 : Cirrus
05 : Novus
06 : Y ak-54
01 : GeeBee
01 : GeeBee
03 : Extra
CONTINUE? NO YES
02 : Axe 100
03 : Extra
04 : Cirrus
05 : Novus
06 : Y ak-54
01 : GeeBee
MODEL
RESET
05 : Novus
CONTINUE? NO YES