User Manual

12
Unscrew the left gimbal assembly and lift it out of the transmitter
case. Slide the elevator arm onto the mounting pin in the left gimbal
in the same way you removed it from the right gimbal. NOTE:
As you can see, the two gimbals are identical but installed
in the transmitter 180 degrees opposite each other. Insert the
spring clip you removed from the right gimbal into the slot of the
left gimbal beneath the tensioner screw. Reattach the spring you
removed from the right gimbal onto the left. Reinstall the left gimbal
assembly and tighten the spring tensioner screw to your liking.
Close the transmitter as explained in the CASE SEPARATION AND ASSEMBLY section.
CONTRAST
Adjust the LCD’s contrast level for optimum viewing.
LCD BRIGHTNESS
Adjust the intensity of the display’s blue backlight.
BEEP VOLUME
Adjust the loudness of the radio’s beeper as desired. This volume setting affects all
tones that are emitted from the radio including while making adjustments such as trim
adjustments, programming changes, etc. Beep volume for all alarms is not adjustable.
BATTERY ALARM
An alarm will sound and the display will show “LOW BATTERY” when the Tx battery’s
voltage drops to the level shown in this setting. Do NOT set this value too low, as the
radio could lose power very rapidly as the battery nears full discharge and cause a loss
of control of the model. Land the model immediately once this alarm has sounded!
Battery type
Nickel-Cadmium (NiCd)
or Nickel-Metal
Hydride (NiMH)
4.00V 4.40V 4.00V
Alkaline 4.00V 4.00V 3.60V
Default Recommended Minimum
Once all functions in this menu are set, press ESC to return to the home screen.