User Manual

11
Fundamental settings for the transmitter are located in this
menu. With the power switch in the OFF position, press and
hold ENTER, turn the power switch ON and wait for the
SYSTEM SETUP screen to show. Move the cursor and press
ENTER to select any setting. Press or to change
settings. Press ENTER to con rm the setting.
USER NAME
Enter your name to identify the
radio. The cursor will be under the
 rst character to enter. Press
or to  nd the desired character,
then ENTER to con rm. The cursor
will automatically move to the next
character. Selecting
or can move the cursor freely. Repeat as necessary for up to
8 characters. Pressing CLEAR will move the cursor back one space and erase the
character in that space. Press ESC when  nished.
STICK MODE
The TTX660 is factory set to Mode 2 con guration, but can
be changed to Mode 1 (elevator on left, throttle on right). To
change modes in the programming, move the cursor to the
STICK MODE line, highlight and press ENTER, then press
or . Press ENTER to con rm.
In addition to programming changes, stick mode changes require reversal of the throttle
ratchet and elevator arm/spring. Refer to the CASE SEPARATION AND ASSEMBLY
section on page 7 for opening and safely re-assembling the case after the mechanical
adjustments are made. Failure to do this properly can cause permanent damage to
the radio and void the warranty.
Unscrew the right gimbal assembly by removing the four screws
from the front of the transmitter (make a note of the different length
screws and their locations) and then lift it out of the transmitter case.
It is not necessary to disconnect any of the wires. With the gimbal
in hand, carefully unhook the elevator spring from the elevator arm
using needle-nose pliers (A). Unhook the spring from the lower
spring clip and then slide the spring clip out of the gimbal assembly
(B). Raise the elevator arm to a vertical position and slide it off the
mounting pin (C). Reinstall the right gimbal into the transmitter.
Do not over-tighten the mounting screws! Remove the ratchet
bar from the left gimbal assembly by unscrewing the two mounting screws and install
it onto the right gimbal assembly in the same manner over the ratcheted surface. Use
the adjustment screw to set the ratchet tension to your liking (D).
SYSTEM SETUP
USER NAME :
STICK MODE:
CONTRAST :
BEEP VOL. :
BATT.ALARM:
TACTIC
MODE2
0
0
4.8v
SYSTEM SETUP
ABCDEFGHIJKLMNOP
QRSTUVWXYZabcdefghi
jklmnopqrstuvwxyz01
USER NAME
USER:
LEFT
STICK
Rudder
Mode1: Elevator
Mode2: Throttle
Mode1: Throttle
Mode2: Elevator
Aileron
RIGHT
STICK
NORMAL STICK CONFIGURATIONS