User Manual

10
The LCD contrast and brightness is adjustable for optimum viewing. Six pushbuttons
navigate the menus and settings. Single button pushes will result in a single incremental
adjustment on-screen. Holding a button for a short time will result in slow scrolling of
adjustments; continued holding will result in fast adjustments.
Left side buttons:
Press any time to see the servo position screen shown above. Indicators
for certain channels will change depending on model type, wing type, etc.
Moving any Tx control will graphically be shown on this screen. When
setting / adjusting mixes to determine if the mix is as desired, set the
mix and then view this screen. Move all controls to determine if the mix
moves each respective channel as needed.
Quickly resets certain values and settings back to factory defaults. Press
to backspace in the model and user name screens.
Jumps back to the previous screen, and removes certain pop-up messages
from the screen.
Right side buttons: adjustment of values on-screen
Moves the cursor up, and for increasing highlighted values/settings.
Moves the cursor down, and for decreasing highlighted values/settings.
To select or de-select a setting, or enter a screen. Press brie y to access
the SETTINGS menu. Press and hold to access the MODEL SETUP menu.
LCD, PROGRAMMING CONTROLS,
MENU NAVIGATION
1
0
%
AILE
2
ELEV
3
THRO
4
RUDD
5
AUX1
6
AUX2
0
%
0%
0%
0%
0%
10%
2
0
%
3 58%
40%
50%
6 58%
-
-
-
-
AILE
ELEV
THRO
RUDD
GYRO
PITC