Manual

P26document version 1.0 | © 2022 tacterion GmbH | all rights reserved
6.3.3 plyon® flex Slider Feedback LEDs
For the slider feedback unicolor white LEDs with a change in brightness are used.
The logic behind it can be read as follows:
1. 6x1 LED array to indicate the finger position with 1 being closest to the flex-tail and
6 being the tip of the sensor.
2. The illuminated LEDs add up, e.g. for position 4, LEDs 1-4 remain active.
3. the brightness indicates the force level at the given position with
low intensity = low force
high intensity = high force
HINT: The slider sensor works either way: silicone or PET side up. Again, due to
fixed routing, flipping the sensor also flips the direction of the mapping for the LED
sequence.