Manual

6 STANDALONE

6.1 Power the Board

Micro USB 5V

The D-01 PCB can either be supplied using a 5V USB port on any PC/Laptop/Powerbank

or with an 5V AC socket adapter.

If the board is correctly powered, the status LED on the HCU should be active (green,

blinking).

The „standalone“ mode of the plyon® ﬂex development kit allows direct onboard

interaction without having to connect additional hardware or installation of readout

software. Its strength lies in intuitive and quick learning of how the sensors function and

what affects sensor performance and characteristics most. For detailed signal analysis

or even table top prototype mockup setups please visit the respective chapters „data

stream“ or „prototype“.

ATTENTION: Connect to one power supply only! either USB or through the pin header

input (read more about powering the system via the pin header in chapter 8). Connecting

two power supplies simultanously may result in damages to the device and sensors or

injury and property damage.