Install Instructions

Troubleshooting
If the EWF enters the Flood Protection Lockout, the system should be examined to determine the reason for the lockout
condition.
The EWF contains sophisticated electronics to detect circuit failures. In the unlikely event that the EWF detects a circuit failure,
the Status LED blinks red, the feed valve closes, and the control enters a failsafe state. The user must remove and re-apply
power from the EWF. If the failure is correctable, the EWF will restart normally. If the Status LED continues to blink red, the
control must be replaced.
Maintenance
Disassemble and clean the feed valve's strainer screen at least twice annually.
(7)
doolFtanoitidnoC
tuokcoLnoitcetorP
esuaCelbissoPydemeR/sliateD
relioBdellifrevO
tonffotuCretaWwoL
ylreporpgninoitcnuf
lamronatasiretawnehwFWEehtlangistonseodOCWLehtfI
otrefeR.reliobehtotretawhcumootdeeflliwFWEeht,level
ehtnodellatsnisitahtOCWLehtrofsnoitcurtsnis'rerutcafunam
.OCWLehtgnitsetrofreliob
dexiFfognittesreporpmI
stnuomadeeF
otretawfotnuomadexifreporpenimretedotmetsysreliobtset-eR
deeFdexiFtsujdA.srucconoitidnocretawwolanehwdeef
.gnittesrewolaottnuoma
woLfognittesreporpmI
nOyaleDffotuCretaW
)BOD(kaerB
ebyamBODregnola,reliobehtotnruterotwolssietasnednocfI
OCWLehterofebezilibatsotlevelretawehtwollaotderiuqer
MODasahOCWLehtfI.stratsgnideefdnaretawwolslangis
otrefeR(.yltcerroctesdnadelbanesitieruseb,erutaef
ehtnodellatsnisitahtOCWLehtrofsnoitcurtsnis'rerutcafunam
.)reliob
yaleDfognittesreporpmI
)FBD(gnideeFerofeB
ebyamFBDregnola,reliobehtotnruterotwolssietasnednocfI
.stratsgnideeferofebezilibatsotlevelretawehtwollaotderiuqer
dloHfognittesreporpmI
)WAH(KOretaWretfA
esuacnacgnolootyaledWAHehtgnittes,edomOCWLnI
fotnuomatcerrocehtenimretedotmetsysreliobtset-eR.gnillifrevo
astcetedOCWLehtretfadedeensitahtretawdeeflanoitidda
.levelretawefas
noitidnoCretaWwoL
gnipiproreliobniskaeL.dedeensagnipiproreliobecalperroriapeR
detcurtsboevlavdeeF
.evlavdeefs'FWEnoreniartsehtnepodnasevlavnoitalosiesolC
nethgitdnaecalpeR.reniartsnisirbeddnastisopedynatuonaelC
.yllufsevlavnoitalosinepO.reniarts
ylluftonsevlavnoitalosI
.nepo
tnuomaehttcirtsernacyeht,nepoylluftonerasevlavnoitalosiehtfI
noitalosihtobnepO.FWEehtybreliobehtotdefgniebretawfo
.yllufsevlav
dexiFfognittesreporpmI
stnuomadeeF
otretawfotnuomadexifreporpenimretedotmetsysreliobtset-eR
deeFdexiFtsujdA.srucconoitidnocretawwolanehwdeef
.gnittesrehgihaottnuoma
••
••
•Wiring 120VAC to 24VAC models of the Electric Water Feeder could result in electrical shock or
damage to equipment. Carefully follow the recommended wiring methods in this bulletin.