. MARK VERTICAL AND HORIZONTAL REFERENCE LINE ON DOOR. DETERMINE BACKSEAT TO LOCATE VERTICAL REFERENCE LINE. AIF LOCK STILE IS 4-172" WIDE OR WIDER BACKSEAT IS 2-34". B.IF LOCK STILE IS LESS THAN WIDE, BACKSEAT IS HALF OF THE EXPOSED WIDTH OF LOCK STILE. BACKSEAT ~f [f= VERTICAL CHASSIS TOP AND BOTTOM CHASSIS nerve ton) 41° OR VARIABLE FRM FINISHED FLOOR FINISHED FLOOR 2. PREPARE DOOR TAPE TEMPLATE ON INSIDE OF DOOR ALONG REFERENCE LINE. SPOT AND DRILL HOLE. AMOUNT TOP STRIKE PER LOCATION IN 2ND STEP. 8.
INSTALLATION INSTRUCTIONS SURFACE VERTICAL ROD EXIT DEVICE **BEFORE INSTALLING DEVICE, PLEASE CHECK: 1.IF DOOR FITTED AND HUNG. 2. SIZE OF EXIT DEVICE, FUNCTION AND DESIGN... 2.1.38" DOORS, CAN BE CUT TO FIT DOORS DOWN TO 30" WIDE. 2.2.48" DOORS, CAN BE CUT TO FIT DOORS DOWN TO 36" WIDE. Latch Cover 2.3. HAND OF DEVICE AGAINST APPLICATION.
TEMPLATE FOR SURFACE VERTICAL ROD EXIT DEVICE (1:1) FOR LHR DOOR | Ce @ FOR SEX BOLT DRILL HOLE OUTSIDE H00Q YHA Hod (21) JOSIAH Lix AO¥ CHANTILLY CAVERNS ¥O0d ILVIdWNIL oo ¢ of Device HOLE MUST BE DRILLED —X aD ~~ ACCORDING TO TRIM TEMPLATE.
TEMPLATE of Bottom LATCH FOR SURFACE VERTICAL ROD EXIT DEVICE [Strike 731 (handicap use)] TEMPLATE of Bottom LATCH FOR SURFACE VERTICAL ROD EXIT DEVICE [Strike 730 (regular use)] TEMPLATE of Top LATCH FOR SURFACE VERTICAL ROD EXIT DEVICE (1 1) 29.5 -g 9.
