Installation Guide

ManualsBrandsTACO ManualsCommercial Exit + EntryAlarm Kit for 500 Series Exit Panic Devices — Duronotic Finish

Table Of Contents



•

EAK500 ALARM DEVICE

 



















 























 







 

 



 

 





  









Summary of content (5 pages)

PAGE 1
INSTALLATION INSTRUCTIONS EAK500 ALARM DEVICE • • • • This alarm unit is designed to be used with ED501 touch bar exit device, VR531 vertical bar exit devices, or ETB500 electronic touch bar. It could be used in either alarmed or non-alarmed mode. In alarmed mode siren will sound when bar is pushed. In non-alarmed mode exit device will operate without sounding alarm.
PAGE 2
3 �_ Attaching AJarm Unit to Sliding Cover as Now slide Alarm Unit in;J;liding Cover-by first i�;�rting end of ��it into groove of Sliding Cover indicated below then by drop-ping over Mortise Cylinder. Now is the time to push the Mortise Cylinder all the way through Sliding Cover and Alarm Unit until face of Mortise Cylinder is touching Sliding Cover. Hold assembly together in place by pushing both Mortise Cylinder and Alarm Unit against Sliding Cover. \ Note: Make sure that Support Bracket Arm is prop
PAGE 3
5 INSTALLING BATTERY AND TESTING·ALARM UNIT -· .. ' ;�. '. Install 9V battery, check . and test that Alarm Onit is functioning properly before installing back into exit . device. Press Trigger Switch Arm to activate alarm, if alarm sounds unit is workfng property. You can shut alarm off by turning Mortise Cylinder Key so that Upper Auxiliary Arm depresses Shutoff Switch as shown in diagram below. Diagram showo�witl"l-Alarm Unit-itralam1ed·mode.- -._ 6 . INSTALLING ALARM UNIT _ A=--�; J_ 1.
PAGE 4
3 SlRIKE MAGNET 125 VAC caa 0000000 _/ -· NO ·= 000000 I 12 Yl)C + COM • I D= cc cc CCI cc Cl Cl cc CJ 4 5 ADJUSTING TIMER APPLICABLE ONLY WITH MAGNET OR STRIKE INSTALL ATION. CHECK WIT H YOUR LOCAL AUT HORITIES FOR SUCH APPLICATION Holding Alarm Unit with cylinder side on top, Turn timer counter.clockwise to set to zero, immediate egress. Turn timer clockwise to adjust from zero to thirty seconds for delay egress.
PAGE 5
EXPLODED VIEW . ,. Main Arm Arms Collar Trigger Switch Support Bracket Arm Seat Low Auxilary Arm Retaining Spring under here Retaining Ring Upper Auxiliary Arm .0r "',-_· -� Lower Auxiliary Arm �--- Dry �elay Contact ---�-- Shut off Switch Mortise Cylinder Hole n---- Support Bracket Arm _,___ Support Bracket Sliding Cover /a' .