Installation Guide

Plant I.D. 001-4225
EFFECTIVE: September 1, 2014
102-500
Instruction Sheet
554-7 Wireless Remote Transmitter & Receiver Kit
554-8 Wireless Transmitter Button
Model #: 554-7 Wireless Remote Transmitter & Receiver Kit
Kit Includes:
3 Wire Nuts
1 Remote Transmitter Button
INSTALLATION INSTRUCTIONS
1.
The remote receiver is the small black rectangular box with three protruding wires (white,
black, green). Connect the white, black, and green wires from the remote receiver directly to
the corresponding white, black, and green wires on the circulator control box by twisting each
same colored wire together with the wire nuts provided.
2.
When installing the remote receiver under a sink, mount the remote receiver toward the front of
the cabinet (transmitter range is about 70'). If the transmitter button will activate the pump from
a short distance, but not from further away, the receiver may need to be relocated for better
reception. Strapping the receiver to the front of the drain trap facing outward will optimize
reception.
4.
NOTE: The remote transmitter button included with the remote is synced for use. It
does not need programming.
5.
For additional Wireless Remote Transmitter Buttons, use model 554-8.
3.
Troubleshooting Note
If the circulator does not start when the remote receiver is properly wired to the circulator and
mounted, follow the steps below to ensure the electronic control board is set to the correct
voltage.
Unplug the circulator from the power outlet.
Remove the circulator electrical box cover and carefully remove the electronics control
board from terminal strip.
Turn control board over and locate voltage dip switches in top left corner of board.
(Refer to diagram).
Slide off the Jumper from the connector pins marked "5v" and slide on to the
connector pins marked "12v."
Insert control board firmly into terminal strip and replace electrical box cover.
I.
II.
III.
IV.
1 Remote Receiver
V.
CONTROL BOARD
5v 12v
VOLTAGE
DIP SWITCHES
(Slide jumper to “12v”
for motion sensor activation
and/or wireless remote
receiver/transmitter application)
∆T ADJUSTMENT
(Set on 12 o’cloc
k
position for 5˚ ∆T)