Brochure

An advanced Green hydronic
heating and cooling system
that delivers better comfort,
lower first costs, lower energy
and maintenance costs,
lower life cycle costs, and
reduced design, start-up, and
commissioning time.
LoadMatch® hydronic piping
distribution systems utilize
a primary single pipe loop
joined with a decoupled
secondary piping loop for all
Terminal Unit
Secondary
Circulator
Expansion Tank
Primary
System Pump
Chiller
Single Pipe Loop
Air Separator
Dedicated Coil Circulators - Control Valves Are Not Requried
terminal units. In addition
maintenance free wet rotor
circulators are substituted for
control valves in this decou
-
pled secondary loop.
Chiller
Terminal Unit
(Chilled Beam)
LOFlo Mixing Block
Dedicated Coil Circulators
(Control valves not required)
Expansion
Tank
Single Pipe Loop
Primary System Pump
Air Separator
The Taco LOFlo System is used
in hydronic heating and cooling
systems to significantly reduce
the flow of water. Typically used
in radiant panel (ceiling, wall or
floor) and chilled beam (passive
and active) applications, the
technology significantly reduces
pump flows and pipe sizes for
reduced energy consumption
and lower first costs. The LOFlo
System also provides precise
control of supply water to the
terminal, e.g. chilled beam, and
precise control of room tem-
peratures.
The basic concept of the LOFlo
Mixing Block, shown here, is to
provide a complete injection
mixing station in a simple fac-
tory assembled package that
controls each individual zone
at the lowest possible flow rate
by maintaining the highest pos-
sible supply water temperatures
in cooling and lowest possible
supply water temperatures in
heating.
LOFlo® Mixing Block and iWorx®
CHB2 Chilled Beam Controller
Scan with your
SmartPhone to
learn more.
Scan with your
SmartPhone to
learn more.
 18 