00 Series Plumb N Plug Circulator Pump Instruction Manual

Programming your Digital Timer:
A. Setting the current time on the LCD display
1. Move Programming Switch to
2. Press the (R) Reset key.
Clock face will display
“AM 12:00”.
3. DAY arrow will flash below the number 1 (Monday).
Press the (+) or (-) key to move arrow to the correct
day (1= Mon, 2= Tues, 7= Sun, etc), then press
(OK). HOUR will flash.
4. Press (+) or (-) to change HOUR to current time, be
sure the AM/PM symbol is correct, then press (OK).
MINUTE will flash.
5. Press(+) or (-) to change MINUTES to correct time,
then press (OK). SECONDS will flash.
6. Since SECONDS will not be used, simply press
(OK). Your current time is set.
7. Move Programming Switch to RUN.
B.Programming the Digital Timer ON/OFF settings
NOTE: It is helpful to write out the program timer
schedules before beginning programming. See last
page for an example.
To program timer for ON operation
1. Move Programming
Switch to (P), display
will show “-01-”. This is
your first ON setting.
2. Press (P) Program
Selection Key. Display
will read “--:--”.
3. Press (+) key. Display will
show a flashing arrow
below the numbers 1-7
(Monday-Sunday), the
time will read “AM
12:00:00” and a light
bulb will appear to the right of the time, signifying
an ON time setting. Press the (+) or ( - ) key to
move the arrow through the DAY selection options:
4. When correct DAY(S) setting is selected, press
(OK), HOUR time will flash.
5. Press (+) or (-) key to set HOUR to the desired time.
Be sure the “AM/PM” symbol is correct. Then press
(OK), MINUTES time will flash.
6. Press (+) or (-) key to set MINUTES to desired time.
Then press (OK), SECONDS will flash.
7. Since SECONDS are not necessary, simply press
(OK). Your first ON time is set.
8. Press (P) Program Selection key to finish.
Display will show “-02-”.
Timer is now ready for
an OFF timer program.
To program timer for OFF operation
1. Repeat steps 2 thru 8 to complete OFF time set-
ting. For OFF settings, no light bulb will appear on
the clock face.
Repeat the above procedure to program each ON (odd
number) and OFF (even number) desired time setting, in
sequential order. Refer to Timer Schedule on back page.
To finish and set digital timer to AUTO operation
1. When all programs are completed, move
Programming Switch (P) to RUN position.
2. Move Manual Operation switch to AUTO. Timer will
now operate ON/OFF according to programmed
settings.
DISPLAY ARROW INDICATOR DAYS
1 MONDAY
2 TUESDAY
3 WEDNESDAY
4 THURSDAY
5 FRIDAY
6 SATURDAY
7 SUNDAY
12345 MON - FRI
67 SAT - SUN
123456 MON - SAT
1234567 MON - SUN
AM 12:00: 00
-01-
--:--
AM 12:00: 00
-02-
PM 06:45: 00