Instructions / Assembly

4. Wiring the circulator: Disconnect AC power supply. Remove terminal box cover. Attach a wiring connector into knockout hole.
Use flexible conduit only. Connect Line/Hot power to the black lead, Neutral to the white lead. See wiring diagram above. The
0015e3 is a double insulated circulator; no grounding wire is necessary. Replace terminal box cover. Insert cap plug provided to
cover unused knockout hole.
Note: If pigtail leads provided are not used, be sure to trim field wire to a strip length of .25" (+/- .025") to prevent exposed wire causing
a short at the terminal plug. Connect line and neutral to green terminal plug as shown in diagram. Depress the spring tab with a small
screwdriver to insert wire into plug. Release tabs to complete connection.
5. Start the circulator: When purging the system, it is recommended to run the circulator at full speed long enough to remove all
remaining air from the bearing chamber. This is especially important when installing the circulator in the off-season. An orange LED
will illuminate when the 0015e3 is powered on.
6. Green Mode: Responsive technology actively monitors system conditions and automatically adjusts to optimize power consumption.
Full Speed Operation:
To run the pump at full speed during the fast fill, start-up and purge process, rotate dial to HIGH setting. To return to the normal oper-
ating mode, turn dial to desired LOW, MEDIUM or HIGH setting.
CAUTION: Never run the circulator dry or permanent damage may result.
ATTENTION: Ne laissez jamais le circulateur tourner à sec, des dommages permanents peuvent en résulter.
NEUTRAL
TERMINAL BOX
L N
No ground wire is required.
Green Terminal Plug
Spring Tabs
WIRE NUT
WHITE
BLACK
LINE
WARNING: SERVICING OF DOUBLE-INSULATED APPLIANCES. A double-insulated appliance is marked with one or
more of the following: The words “DOUBLE INSULATION” or “DOUBLE INSULATED” or the double insulation symbol
(square within a square). In a double-insulated appliance, two systems of insulation are provided instead of ground -
ing. No grounding means is provided on a double-insulated appliance, nor should a means for grounding be added.
Servicing a double-insulated appliance requires extreme care and knowledge of the system, and should be done by
qualified service personnel. Replacement parts for a double-insulated appliance must be identical to the parts they
replace.
AVERTISSEMENT : ENTRETIEN DES APPAREILS À DOUBLE ISOLATION. Un appareil à double isolation est marqué
avec un ou plusieurs des éléments suivants : les mots « DOUBLE INSULATION » ou « DOUBLE INSULATED » ou le
symbole de double isolation (carré dans un carré). Dans un appareil à double isolation, deux systèmes d'isolation
sont fournis plutôt que la mise à la terre ; aucun moyen de mise à la terre n’est fourni ni ne doit être ajouté. L'entretien
d'un appareil à double isolation exige de grandes précautions et une connaissance approfondie du système, et doit
être effectué par un technicien qualifié. Les pièces de rechange pour un appareil à double isolation doivent être iden-
tiques aux pièces remplacées.
-5-