Safety data sheet

SAFETY DATA SHEET (REGULATION (EC) n° 1907/2006 - REACH) Version 1.1 (12/04/2016) - Page 3/6
T2M
AFTER RUN OIL
Storage
Keep the container tightly closed in a dry, well-ventilated place.
The floor must be impermeable and form a collecting basin so that, in the event of an accidental spillage, the liquid cannot spread beyond this
area.
Packaging
Always keep in packaging made of an identical material to the original.
7.3. Specific end use(s)
No data available.
SECTION 8 : EXPOSURE CONTROLS/PERSONAL PROTECTION
8.1. Control parameters
No data available.
8.2. Exposure controls
Personal protection measures, such as personal protective equipment
Pictogram(s) indicating the obligation of wearing personal protective equipment (PPE) :
Use personal protective equipment that is clean and has been properly maintained.
Store personal protective equipment in a clean place, away from the work area.
Never eat, drink or smoke during use. Remove and wash contaminated clothing before re-using. Ensure that there is adequate ventilation,
especially in confined areas.
- Eye / face protection
Avoid contact with eyes.
Use eye protectors designed to protect against liquid splashes
Before handling, wear safety goggles in accordance with standard EN166.
- Hand protection
Wear suitable protective gloves in the event of prolonged or repeated skin contact.
Type of gloves recommended :
- Butyl Rubber (Isobutylene-isoprene copolymer)
- Body protection
Work clothing worn by personnel shall be laundered regularly.
After contact with the product, all parts of the body that have been soiled must be washed.
SECTION 9 : PHYSICAL AND CHEMICAL PROPERTIES
9.1. Information on basic physical and chemical properties
General information :
Physical state : Fluid liquid.
Colour: Yellowish.
Odour: Fruity.
Important health, safety and environmental information
pH : Not relevant.
Boiling point/boiling range : 274 °C.
Flash Point Interval : PE > 100°C.
Vapour pressure (50°C) : Below 110 kPa (1.10 bar).
Density : 0.97 (25°C)
Water solubility : Insoluble.
Viscosity : 160 mm²/s (25°C)
Self-ignition temperature : 186 °C.
% VOC : 0.03
9.2. Other information
Solids content: 1.5%
- Made under licence of European Label System® MSDS software from InfoDyne - http://www.infodyne.fr -