User Instructions

Safety instructions
T12CVS8 HBM: public 7
Approval from Industry Canada (IC)
This device complies with the Industry Canada standard RSS210.
This device complies with the RSS requirement(s) of Industry Canada for ex-
emption from licensing regulations. Compliance with the following two condi-
tions is a requirement of operation: (1) This device may not cause harmful in-
terference; and (2) this device must tolerate any interference signal, including
interference that could cause undesirable operation of the device.
Cet appareil est conforme aux norme RSS210 d’Industrie Canada.
Cet appareil est conforme aux normes d’exemption de licence RSS d’Industry Canada.
Son fonctionnement est soumis aux deux conditions suivantes : (1) cet appareil ne doit
pas causer d’interférence et (2) cet appareil doit accepter toute interférence,
notamment les interférences qui peuvent affecter son fonctionnement.
Intended use
The T12CVS8 torque flange is used exclusively for torque, angle of rotation
and power measurement tasks within the load limits stipulated in the
specifications. Any other use is not appropriate.
Stator operation is only permitted when the rotor is installed.
The torque flange may only be installed by qualified personnel in compliance
with the specifications and with the safety requirements and regulations of
these mounting instructions. It is also essential to observe the applicable legal
and safety regulations for the application concerned. The same applies to the
use of accessories.
The torque flange is not intended for use as a safety component. Please also
refer to the "Additional safety precautions" section. Proper and safe operation
requires proper transportation, correct storage, siting and mounting, and
careful operation.