User Instructions

T12-Assistent, Version 1.2
66 HBM: public T12CVS8
Checking / reading calibration information
If a calibration is present (active or inactive) it will be displayed as readable in
the system menu under "Read calibration of frequency output" no later than
after the T12 Assistant is restarted. This makes it very easy to check at a
glance whether or not a calibration is present.
Information
The display can only be read if a calibration is active (i.e. switched to "ON")
Information
The T12 Assistant does not show the updated menu settings under XP until
after the T12CVS8 is restarted (switch OFF/ON)
Factory settings
If the factory settings are loaded, the calibration of the current parameter set
becomes inactive. It will also be deleted if it has not been saved to a parameter
set before the transducer is turned off!
The factory settings can be found under Save / Load.