User Instructions

Mechanical installation
32 HBM: public T12CVS8
- then stays permanently green (CAN bus) or yellow or green
(PROFIBUS).
Information
When data are being exchanged via the CAN bus or the PROFIBUS, the LED
flashes green.
You can also use the T12 Assistant to check for the correct alignment. The
LED must stay green in the "Rotor clearance setting mode".
7. Now fully tighten the fastening screws (tightening torque 14 N·m).
8. Remove the spacers, by first removing the adhesive strip and then the
red plastic strip.
9. Make sure that the air gap between rotor and stator is free from electrically
conductive and other foreign matter.