User Instructions

Mechanical installation
T12CVS8 HBM: public 31
8.5.2 Aligning the stator
1. Position the stator on an appropriate mounting base in the shaft train, so
that there are sufficient opportunities for horizontal and vertical adjustments
to be made.
2. Should there be any misalignment in height, compensate for this by insert-
ing adjusting washers.
3. Initially, the fastening screws should only be hand-tight.
4. Use the spacers to radially align the stator to the rotor.
5. Use the spacers to axially align the stator to the rotor. The rotor should be
in line with the edge of the red spacer, see Fig. 8.18.
Fig. 8.18 Axial alignment to the rotor
6. Connect the power line (plug 1 or plug 3). Watch the LED to the right of
plug 4. The stator is correctly aligned when the LED successively
- flashes red for about 10 seconds
- flashes yellow for about 10 seconds
Transmitter rotor
Alignment line
Spacer