User Instructions

Mechanical installation
26 HBM: public T12CVS8
8.5 Installing the stator
On delivery, the stator has already been installed and is ready for operation.
There are four tapped holes on the base of the stator housing for mounting the
stator. Externally, two with a metric M6 thread, internally, two with a UNF 1/4"
thread (closed with a plastic threaded pin).
For mounting with a metric thread, we recommend using two DIN EN ISO 4762
socket head cap screws with hexagon sockets of property class 10.9 of the
appropriate length (depending on the connection geometry – not included
among the items supplied; tightening torque = 14 N·m).
Tip
Allow for possible adjustment when aligning the stator to the rotor (e.g. provide
slotted holes).
The stator can be mounted radially in any position (for example, "upside down"
installation is possible). You can also install the stator over the protection
against contact (option), see Section 8.6.3.
Fig. 8.12 Mounting holes in the stator housing (viewed from below)