Owner's Manual

3
7. Run white power wire across engine bay from vehicle specific fuse holder, following the firewall across, going over the brake booster
and down the firewall. Follow the Jeeps frame watching for pinch points, or exhaust components to drivers grommet floor hole.
Secure wire with included zip ties. Slide grommet over white power wire and install grommet.
8. Mount the black ground wire to the factory ground points in the kick panels with a 10 mm socket. Scrape paint away from ground
mounting location to expose bare metal. The ground wires ring terminal must be placed against the metal of the vehicle. Run ground
wire to under seats.
9. Using a pull rod, route the RCA and remote wire cable from the radio cavity then under the center console, the 4-channel cabling goes
to the drivers side, the Subwoofer route to the passengers side.
10. Route subwoofer wire under trim until you reach the rear bench seat. Then pull up carpet, and route wires under carpet into the cargo
area and connect to subwoofer box. Use caution to avoid the scissor mechanism used to fold the seat down.