Owner's Manual

2
4. Using a pry tool and 10 mm socket, unhook the door catch then remove door seal and kick panel cover.
5. 1. Unclip and remove the panel below the steering column. (Figure A), Unclip the climate control panel and set aside. (Figure B),
Remove (2) Phillips screws securing the radio trim panel, then unclip and remove the panel. (Figure C), Remove (4) Phillips screws
securing the radio, then unplug and remove. (Figure D)
Figure A
Figure B
Figure C
Figure D
See diagram on page 5 for overview
6. Run red power wire down firewall, and follow the Jeeps frame watching for pinch points, or exhaust components. Locate the
passengers grommet floor hole. Secure wire with included zip ties. Slide grommet over red power wire and install grommet.