Owner's Manual

See diagram on page 5 for overview
1. Run red power wire down firewall, and follow Jeeps frame watching for pinch points, or exhaust components. Locate the grommet
floor hole. Secure wire with included zip ties. Slide grommet over red power wire and install grommet.
2. Mount the black ground wire to the factory ground point in the passenger kick panel with a 10 mm socket. Scrape paint away from
ground mounting location to expose bare metal. The ground wires ring terminal must be placed against the metal of the vehicle. Run
ground wire to under passenger seat.
3. Using a pull rod, route the RCA and remote wire cable from the radio cavity into the glovebox cavity, then under the center console,
and out under the passenger seat.
4. route subwoofer wire under trim until the rear bench seat. Then pull up carpet, and route wires under carpet into the cargo area and
connect to subwoofer box. Use caution to avoid the scissor mechanism used to fold the seat down.
P:3